Patton is a US based company but by default their units are not configured for US standards.
Here is how to add US tones and configure the FXS ports to simulate standard US POTS lines:
First for the tone profile:
profile call-progress-tone US_Dialtone
play 1 1000 350 -13 440 -13
profile call-progress-tone US_Alertingtone
play 1 1000 440 -19 480 -19
pause 2 3000
profile call-progress-tone US_Busytone
play 1 500 480 -24 620 -24
pause 2 500
profile call-progress-tone US_Releasetone
play 1 250 480 -24 620 -24
pause 2 250
profile tone-set US
map call-progress-tone dial-tone US_Dialtone
map call-progress-tone ringback-tone US_Alertingtone
map call-progress-tone busy-tone US_Busytone
map call-progress-tone release-tone US_Releasetone
map call-progress-tone congestion-tone US_Busytone
Next we need to configure the ports and interfaces.
port fxs 0 0
end-of-call-signaling loop-break 1200
use profile fxs us
encapsulation cc-fxs
bind interface FXS0 switch
interface fxs FXS0
caller-id-presentation mid-ring
caller-id-format bell
use profile tone-set US
This must be repeated for each FXS port.
The above settings will set the FXS ports to use the US tones, caller id, other settings needed to simulate standard “Bell” lines.
You will also need to apply the US tones to the SIP interface:
interface sip SIP1
use profile tone-set US
VoIP4EA 