Archive for January 14, 2012

Adtran Total Access Debug Commands

Posted: January 14, 2012 in Adtran, System Configuration, VoIP Gateway
0

Here is a great post by Mark Holloway that lists the most commonly used debug commands for the Adtran Total Access:

http://www.markholloway.com/blog/?p=315

Debug Output

Command Description
show debugging shows current enabled debug commands
debug sip stack messages shows sip debug information
debug isdn l2-formatted shows isdn debug information (easier use)
debug voice verbose shows all voice messaging
debug isdn verbose shows all isdn messaging
debug interface T1 0/4 rbs shows robbed bit signaling from CAS circuit
undebug all turns off all debugging

Utility Commands

Command Description
clear count media counters on media-gateway reset
clear counters clears counters on interfaces
no events turns off messages to the current session
ping ping an IP address
traceroute trace the router path to a destination IP address
wall sends a broadcast message to all current users
sip trunk-registration force-register forces sip re-registration

Show Commands

Command Description
show sip trunk-registration shows registration status
show media-gateway summary shows media gateway channel status
show media-gateway channel 0/2.1 shows media gateway channel details
show qos map shows qos map
show flash lists contents of the flash
show run voice [verbose] lists running configuration for voice provisioning
show hosts shows the hosts table with timers
show event-history shows events and terminal commands typed
show interfaces shows interface details
show system shows uptime, firmware version and timing
show thresholds shows thresholds of T1 interfaces
show users shows current users
show voice quality-stats shows call information including lost packets
show voice quality-stats active shows call information including lost
show voice quality-stats active realtime shows call information including lost
show ip traffic TCP and UDP statistics
Advertisement